вторник, 4 октября 2011 г.

carpet panel::Figure 9 pull the old vinyl off of the wheel well and clean the wheel well thoroughly to remove dirt and old glue carpet panel

carpet panel

carpet panel

carpet panel

carpet panel::Figure 9 pull the old vinyl off of the wheel well and clean the wheel well thoroughly to remove dirt and old glue.
When dry, apply glue to both the wheel well and the back of the new vinyl.
When the glue is tacky, press the vinyl into place, starting at the center and working out.
Leave plenty of overlap to be trimmed away later.
Smooth and slightly stretch the vinyl as you apply it to eliminate any wrinkles and bubbles.
Pull loose the vinyl strip on bpost, clean and replace with the new vinyl in the same manner as the wheel well vinyl.
Figure 11 attach the rear cockpit panel by screwing into place.
Use the new rings provided on each screw.

Комментариев нет:

Отправить комментарий